Pulnix TS-9720EN Series Installationshandbuch PDF herunterladen (Seite 81)

Page 69

VIS CAM 300/400 Installation Manual

Appendix B: J-Panel Functional and Connector Description

6.2.3 (b) Trigger output

Description

The trigger output is balanced and the driver is a RS485 transmitter (LTC1480).

Signal levels

The signal levels are at standard RS485 levels. The specification below is taken from Linear

Technologies datasheet for LTC1480:

TABLE 16. Signal parameters and conditions.

Electrical interface on the J-Panel:

FIGURE 65. J-Panel electrical interface

6.2.3 (c) Ethernet Interface

100 Mb Ethernet interface. The signals are routed directly to RJ45 connector X11. The cable to the

camera must be a Cat 5e or preferably a Cat 6 cable. The wire color marking on the PCB uses standard

Ethernet wire colors.

6.2.3 (d) Power output

Voltage 24VDC from power supply connected to X6 or X7

Current 2A fused

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 115 116

Keine Kommentare

Pulnix TS-9720EN Series Installationshandbuch Seite 81