Pulnix TS-9720EN Series Installationshandbuch Seite 67

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 116
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 66
Page 55
VIS CAM 300/400 Installation Manual
Appendix A: Camera Functional and Connector Description
5.3.9 (a) Connector physical Interface
TABLE 13. Physical interface pinouts.
The Gnd signal on pin 1 is connected to the Gnd signal on X5 (pin 2) internally on the board.
5.3.10 Typical Wiring Diagram
Figure 52 shows how to connect to the 2
nd
DC Flash unit having the I/O Board electronics powered
from the Flash Power Supply.
FIGURE 52. Wiring a second DC flash from the flash power supply.
Pin Signal Description Connection to
1 Gnd Light/Flash Gnd Light/Flash ground (negative power terminal)
2 Out Light control/Strobe out Light control input or strobe input on flash unit
3 Stat Light/Strobe status Light/Flash Status output from unit
4FPWR
Light/Flash power Power from Light/flash unit to output circuit on
I/O Board
Seitenansicht 66
1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 115 116

Kommentare zu diesen Handbüchern

Keine Kommentare