Pulnix TS-9720EN Series Installationshandbuch PDF herunterladen (Seite 48)

Page 36

VIS CAM 300/400 Installation Manual

System Set-Up

FIGURE 31. Initial Camera Alignment Display example.

8. Turn on the “Roll Bar” display on the Setup computer and then roll the camera mount until the hor-

izontal bumper and trunk seams on the vehicle appear perfectly level with the horizontal line of the

display. Use one 7/16" closed-end wrench on the roll gear to fine-tune the roll angle. Hold the roll

position with the wrench while you use a second wrench to gently tighten the other roll bolts. Then

apply both wrenches to corresponding bolts on opposite sides of the mount. Twisting in opposite

directions to fully secure all of the roll bolts. This approach prevents the roll adjustment from

changing while you tighten the bolts. See Figure 32.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 115 116

Keine Kommentare

Pulnix TS-9720EN Series Installationshandbuch Seite 48