Pulnix TS-9720EN Series Installationshandbuch PDF herunterladen (Seite 39)

Page 27

VIS CAM 300/400 Installation Manual

Installing the Vehicle Imaging System

3.3.6 X15 Lane Controller Connector (X4 and X5)

The Lane Controller connection to the J-Panel is connector X15. The connections are listed in Table 8 .

TABLE 8. X15 Lane Controller

It is possible to have one Lane Controller connected to several cameras or one Lane Controller to each

camera:

One Lane Controller for two or more cameras

1. The Lane Controller is connected to the X15 pin 1 and 2 (no connections to pin 4 and 5)

2. Switch S2 position “OPEN”

3. The Lane Controller can be connected to more J-Panels by connecting RJ45 patch cables between

connector X4 and connector X5 on the next J-Panel (and from X4 on the next J-Panel to X5 on the

third J-Panel). Switch S2 on the other J-Panels must also be in the “OPEN” position.

Two Lane Controller to two cameras

1. The Lane Controller for camera 0 is connected to X15 pin 1 and 2

2. The Lane Controller for camera 1 is connected to X15 pin 4 and 5

3. Switch S2 position “TERM”

4. Do not connect any cables to X4 and X5

FIGURE 25. Two lane controller.

X15 Pin # Signal Description Connection to

1 D0+ RS485 databus D0+ Lane Controller databus 0+

2 D0- RS485 databus D0- Lane Controller databus 0-

3 Gnd gnd gnd

4 D1+ RS485 databus D1+ Lane Controller databus 1+

5 D1- RS485 databus D1- Lane Controller databus 1-

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 115 116

Keine Kommentare

Pulnix TS-9720EN Series Installationshandbuch Seite 39