Pulnix TM-7200 Bedienerhandbuch PDF herunterladen (Seite 24)

OPERATION

Page 16 TM-7200/TM-6200 High Resolution Digital CCD Camera

3.1.5 (c) Continuous Sync Output Option (OP51) )

When async reset is applied, video sync is also reset asynchronously. This phenomenon causes video

picture rolling or bouncing on the monitor. With this option, a continuous output (no more bouncing or

rolling pictures) will be achieved at async reset.

FIGURE 8. Continuous Sync Output

3.1.6 Timing

3.1.6 (a) Digital Video

Differential line-driven, 10-bit parallel signal with EIA-422 format. 100Ω output termination

impedance. Output from 31-pin connector. Mating connector: Airborne MP211-031-113-4300. Please

consult digital cable information, e.g., 50-13-1-01, 30DG-02 (8-bit) or 30DG-02-10 (10-bit), 2m cable.

3.1.6 (b) Line Data Valid

This is differential line-driven signal with EIA-422 format. It is active high (+ side is higher than - side)

during the transfer of each line of data, producting horizontal line readout.

FIGURE 9. Line Data Valid

ASYNC RESET

ASYNC VIDEO OUTPUT

CONTINUOUS OUTPUT

A A

B B

STANDARD

A: PREVIOUSLY GRABBED IMAGE B: NEW CAPTURED IMAGE

63.5µSec.

2µSec.

LDV

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 39 40

Keine Kommentare

Pulnix TM-7200 Bedienerhandbuch Seite 24