Pulnix TM-7200 Bedienerhandbuch PDF herunterladen (Seite 16)

INSTALLATION

Page 8 TM-7200/TM-6200 High Resolution Digital CCD Camera

2.2.4 (b) 37-Pin D-Sub Connector

2.2.5 Attaching the Video Output

Most users utilize the BNC connector for video output from the camera. Connect the output from the

camera to the input of your monitor, VCR or switching device. The input of the monitor should be

balanced for 75Ω termination. Standard RG-59 type coaxial cable should carry a full video signal for up

to 500 feet.

Users wishing to output the video and input the power and sync to a camera over a single cable can use

the PULNiX multi-conductor cables, such as the 12P-02, the KC-10, etc. The mini coaxial leads in

PULNiX multi-conductor cables are designed for short runs of no longer than 100 feet.

Note: Make sure that no extraneous wires are visible which could cause a short.

Pin# Signal Cable Pin# Signal Cable

1 CLK+ OR 1 RED 20 CLK- OR 1 BLUE

2 LDV+ GRY 1 RED 21 LDV- GRY 1 BLUE

3 FDV+ WHT 1 RED 22 FDV- WHT 1 BLUE

4 N/C 23 GND GRY 2 BLUE

5 FI+ PNK 1 RED 24 FI- PINK 1 BLUE

6 N/C 25 N/C

7 N/C 26 N/C

8 D0+ WHT 2 RED 27 D0- WHT 2 BLUE

9 D1+ YLW 2 RED 28 D1- YLW 2 BLUE

10 D2+ PINK 2 RED 29 D2- PINK 2 BLUE

11 D3+ OR 3 RED 30 D3- OR 3 BLUE

12 D4+ GRY 3 RED 31 D4- GRY 3 BLUE

13 D5+ WHT 3 RED 32 D5- WHT 3 BLUE

14 D6+ YLW 3 RED 33 D6- YLW 3 BLUE

15 D7+ PINK 3 RED 34 D7- PINK 3 BLUE

16 GND YLW 1 RED 35 GND SHIELD

17 VINIT YLW 1 BLUE 36 N/C

18 EN INTEG OR 2 BLUE 37 INTEG OR 2 RED

19 N/C

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Keine Kommentare

Pulnix TM-7200 Bedienerhandbuch Seite 16