Pulnix TMC-6700 Series Bedienungsanleitung PDF herunterladen (Seite 62)

Kamerakabel

_______________________________________________________________________________________________________

INSPECTA hardware manual Rev 1.86 page 62

0xB8C 2 No or single or double pulse

0xB9C 3 No or single or double pulse

For multiple JAI CV-M1 use single trigger shutter mode. See camera switch

setting below for shutter speed selection.

Camera back-panel switches:

1: shutter speed ( see camera manual )

2: shutter speed ( see camera manual )

3: shutter speed ( see camera manual )

4: shutter speed ( see camera manual )

on if double pulse trigger selected

5: off: single or double pulse trigger

on: no trigger but double speed at 500 lines

6,7: off/off: low speed,

off/on: high speed,

on/on: double pulse

8: off: sw1-4 for shutter speed selection

on: RS-232 shutter speed selection

Inside camera switches & jumpers:

Standard factory setup, HD/VD in

6.29 JAI CV-M1 with RS-232

(Part # KKRH**M1R)

for JAI CV-M1 (CAMM1), CV-A1, CV-A11

One of the above cameras is connected to the Inspecta via one cable. There are

two connectors on the camera side, the Hirose 12-P and the Hirose 6-P

connector.

The cable is split on the Inspecta side for an additional connection to one of

the serial connectors (9-pin D-Sub female). This optional cable is app. 20cm

long

CV-M1 modes:

camera mode Nr. of cameras Async shutter

0x8A0 1 no

0x8AC 1 single pulse

0x8BC 2 single pulse

0x95C 3 single pulse