Pulnix TS-9720EN Series Bedienerhandbuch PDF herunterladen (Seite 36)

Page 26

Installation and Operation

VIS 300/400 EN Setup Software

FIGURE 33. Video Window Context Menus

2.6.6 (b) =>Unselect Camera

This command clears the current camera selection and blanks the Video Image display.

2.6.6 (c) =>View Image Properties

This command opens a new window that displays the image properties for the image displayed in the

Video Window. SeeSection 2.6.11 on page 39 for a full description of the Image Properties Window.

2.6.6 (d) =>Manual Exposure

This command opens a new window where the Camera Exposure (Shutter, Gain, Pedestal, VTop/

VBottom and Gamma) can be controlled manually. See Section 2.6.12 on page 42 for a full description

of the Manual Exposure Window. This is typically used when adjusting the cameras in low light

conditions during installation/adjustment at the roadside in the night.

2.6.6 (e) =>Laser Setup

This command opens a new window where a serially connected Laser Trigger can be Setup. See

Section 2.6.14 on page 43 for a full description of the Laser Setup Window. This is typically used when

adjusting and testing the internal trigger setting of the Laser Trigger.

2.6.6 (f) =>Image Processing

This command opens a new window that displays the image processing tools for the image displayed in

the Video Window. Using this Image Processing it is possible to adjust the Gamma-correction,

Brightness, Contrast and Saturation on the displayed images. This will not change the images saved

using ENSetup but the Image Processing can also be activated on the images printed out using the File

Print…menu. See Section 2.6.13 on page 43 for a full description of the Image Processing Window.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 71 72

Keine Kommentare

Pulnix TS-9720EN Series Bedienerhandbuch Seite 36