Pulnix TM-1300 Bedienerhandbuch PDF herunterladen (Seite 15)

Page 7

Installation

TM-4000CL Series Progressive Scan Shutter Cameras

2.2.4 Power Supplies and Power Cable Setup

2.2.4 (a) Power Supplies

The TM-4000CL camera requires 12V DC power that is obtained through the 12-pin connector located

on the rear panel of the camera. PULNiX recommends the following power supplies:

PD-12UU 100-240V AC/12V DC 1.2A universal voltage power supply,

US Plug

PD-12UUP PD-12UU with12-pin connector US plug

PD-12UE PD-12UU European plug

PD-12UEP PD-12UU with 12-pin connector European plug

For users providing power through the 12-pin connector, the PD-12P, PD-12UEP and PD-12UUP

power supplies are available with the 12-pin mating connector already attached to the leads from the

power supply. The PD-12UU and PD-12UE power supplies can be connected to the PULNiX power

cable via a terminal strip or directly.

When wiring the PD-12UU and PD-12UE power supplies directly, please note the following:

• The lead ends must be twisted together and tin-soldered for strength and electrical continuity.

• Shrink tubing or a similar insulator should be used to prevent exposed leads from touching and

shorting.

• The +12V lead is marked with a red stripe or white lettering; be sure not to reverse the leads.

• All connections must be properly insulated to prevent shorting.

2.2.4 (b) PULNiX Power Cables

If you are using PULNiX power cables such as the 12P-02S, please refer to the 12-pin connector pin-

out diagram below. The cable pin-out diagram is shown in Figure 3 below. The color-coded leads use

Gray for Ground and Yellow for +12V.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 39 40

Keine Kommentare

Pulnix TM-1300 Bedienerhandbuch Seite 15