Pulnix TMC-7DSP Bedienungsanleitung PDF herunterladen (Seite 12)

‘Point.mdl’[2] can be used for finding the starting point of the curve. Both axes will move straight

to the desired angle (x_deg, y_deg). Simulation will stop when both axes have reached the desired

angle.

Figure 5 'Model.mdl' - Drawing the curve

I used the model ‘Model.mdl’, created by LingHong[3], to draw the curve on the paper. It was

really easy to use for drawing sine wave or circle. For drawing more complicated curves, a new

model should be created.

Figure 6 Subsystem 'selected input signal' from 'Model.mdl'

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Keine Kommentare

Pulnix TMC-7DSP Bedienungsanleitung Seite 12